Subaru XT 1988 Service Manual page 1055

AIR CONDITIONING SYSTEM
4-7
L4-1552
Fig.
63
/
Snap ring pliers
L4-1553
Fig. 64
a. Do not damage the coil bearing portion.
b. Install the wedge ring with its tapered surface facing up.
(2) Tighten 5 mm
x
8 screws to secure the clamp using
Ph illips-head screwdriver and torque driver.
Tightening torque:
2.7 - 3.3 N·m (0.28 - 0.34 kg-m, 2.0 - 2.5 ft-Ib)
Torque driver
Clamp
L4-1554
Fig. 65
a. Thoroughly wipe off dirt and oir from the clamp mounting
surface on the compressor side.
b. Do not damage the lead and earth wires.
c. Avoid interference of the lead and earth wires with the
pulley.
(3) Carefully install the rotor while rotating it by
a
hand.
Remove dirt and oil from the armature contacting surface.
(4) Install the 40 mm wedge ring using snap ring pliers.
Snap ring pliers
L4-1537
Fig.
66
Install the wedge ring with its tapered surface facing up.
33
(5) Install the key to the key groove in the shaft.
L4-1555
Fig. 67
Make sure the key is free from burrs or any other damage.
(6) Install the spacer ASSY using thickness gauge.
Spacer sizes:
Thickness 0.1 mm (0.004 in), 0.3 mm (0.012 in),
0.8 mm (0.031 in)