Subaru XT 1988 Service Manual page 833

4-2 WHEELS AND AXLES
10) Using HUB STAND (927080000) and a hydraulic press,
drive hub bolts out.
Be careful not to hammer hub bolts. This may deform hub.
Fig. 30
ASSEMBLY
HUB STAND
(927080000)
L4-1466
1) Attach hub COMPL to HUB STAND (927080000) se-
curely.
2) Using a hydraulic press, press new hub bolts into place.
a. Use 12 mm (0.47 in) dia. holes in HUB STAND to prevent
bolts from tilting.
b. Be sure to press hub bolts until their seating surfaces con·
tact the hub.
L4-1472
Fig. 31
3) Clean dust or foreign particles from inside the housing.
4) Using HOUSING STAND (927090000) and BEARING
PULLER (927100000), press a new bearing into place.
. 0
iO
Fig. 32
L4-1467
a. Always press outer race when installing bearing.
b. Be careful not to remove plastic lock from inner race when
installing bearing.
c. Charge bearing with new grease when outer race is not
removed.
5) Install snap ring in its groove.
Make sure to install it firmly to groove.
6) Using OIL SEAL INSTALLER (927110000), press outer
oil seal until it contacts circlip.
Fig. 33
OIL SEAL INSTALLER
(927110000)
Snap ring
HOUSING STAND
(927090000)
L4·1468
7) Invert HOUSING STAND and housing.
8) Using OIL SEAL INSTALLER (927110000), press inner
oil seal until it contacts the bottom of housing.
9) Apply sufficient grease to oil seal lip.
Specified grease
SHELL XSG·6459
a. If specified grease is not available, remove bearing grease
and apply AutoRex A instead.
b. Do not mix different types of grease,
18- .
I