Subaru XT 1988 Service Manual page 1237

CLOCK
Fig. 33
Display
Display range
Function
Time resetting
BODY ELECTRICAL SYSTEM
6-2
ARRIVE
L6-1267
• The current time is displayed by "AM", "PM", and four digits of the 7-segment figures.
While the time is displayed, the CLOCK button on the control unit is illuminated. When the
alarm time is being displayed, the ALARM button on the control unit is illuminated.
• "0" in the left digit of the "minute" position is displayed as "0", but the "0" in the left
digit of the "hour" position is displayed by a blank.
Example: AM 8 hours 3 minutes ..... AM 8 : 03
AM
PM
Display range
1 : 00 to 12 : 59
Minimum display unit
1 MINUTE
• The time is displayed when the CLOCK button is depressed.
• The "AM" or "PM" display flashes once a second with the duty ratio of 50%.
• The time is counted continuously as long as the battery is connected, irrespective of the
display on the display unit.
• Immediately after connecting the battery, the display is "PM 1 : 00", which flashes once a
second with the duty ratio of 50%.
1) The "H", "10M", "M", and "SET" switches function only in the CLOCK function. This
mode is cancelled when the "SET" switch is depressed.
2) Time is being counted even during the time resetting operation.
3) When the "SET" switch is depressed, the CLOCK display is set to a time signal.
o
to 29 second is rounded off (Ex. 10:00
29
-.10:00
00
)
30 to 59 second is carried forward (Ex. 9:59
35
-.10:00
00
)
4) The "H", "10M", and "M" switches function independently and no carrying over is made
from the unit to tens place in the minute range, nor from minute nine to hour position.
5) If "12" is displayed when the "H" switch is depressed, "AM" changes to "PM", and "PM"
to "AM".
6) If "H", "10M", or "M" switch is held in, the displayed number changes for each 0.5 second
for the first 1.5 seconds, then for each 0.25 second afterward. The number increases by one
when the switch is depressed once.
27