Subaru XT 1988 Service Manual page 431

ENGINE AND TRANSMISSION MOUNTING SYSTEM
2-11
20) Remove rear cushion rubber mounting nuts, and rear 22) Remove transmission.
crossmember.
a. Move transmission jack toward rear until mainshaft is with·
drawn from clutch cover. (MIT)
b. Move torque converter and transmission as a unit away
from the engine. (4AIT)
Torque converter
L2-1461
Fig. 44
INSTALLATION
L--_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ L2_.1_1_79....J
1) Install transmission to engine and temporarily tighten
Fig. 42 engine·to·transmission mounting nuts.
21) Turn ENGINE SUPPORT adjuster counterclockwise to
raise the front of engine slightly.
23
a. Gradually raise transmission with a transmission jack until
mainshaft is aligned with clutch disc at their splines. Engage
them at splines. If they are not aligned properly, rotate crank·
shaft as required. (MIT)
b. Be sure not to strike mainshaft against clutch cover. (MIT)
2) I nstall rear crossmember to rear cushion rubber.
Align rear cushion rubber guide with rear crossmember guide
hole and tighten nuts. (A/T)
Fig.
45