Subaru XT 1988 Service Manual page 707

TRANSMISSON CONTROL SYSTEM
3-3
(Selective 4WD)
CD
Bushing
®
Washer
®
Spring plate
@
Bracket CP
CD
Fig. 15
CHECK
@
®
Stay CP
L3474
Check the following parts for deformation, damage, and wear.
Repair or replace any defective parts. Determine defective
parts by comparing with new parts.
1)
2)
CD
Bushing
®
Cushion
®
Spacer
@
Dust seal
®
Link, rod, and lever
®
Joint CP
(J)
Spring
@
Wiring harness (Selective 4WD)
ASSEMBLY
Clean all parts before assembly.
Mount the following parts on the stay CPo
(FWD/Full-Time 4WD)
CD
Bushing
®
Spacer
®
Spring bracket CP
@
Bracket CP
(Selective 4WD)
CD
Bushing
®
Washer
®
Spring plate
@
Bracket CP
9
3) Assemble the plate CP and dust seal.
(1) Tighten with the locking wire [1 mm (0.04 in) dia.J
to the extent that the dust seal will not come off.
(2) Direct the locking wire end toward the plate side so
as not to damage the dust seal.
L3475
Fig. 16
4) Mount the following parts on the lever.
CD
Dust seal
®
Bushing
• Apply grease [SUNLIGHT No.2 (003602010) or
equivalent] to the inner surface of the bushing.
®
Cushion
5) Mount the above-mentioned lever on the stay CPo
(1) Apply sealant on the stay CP su rface mating with the
plate, not at a place inside the bolt hole and where sealant
will fall into the hollow.
Sealant: Butyl rubber tape [1.5 mm (0.059 in) dia.J
(2) Mount the plate CP on the stay CPo
Tightening torque:
14 - 22 N.m (1.4 - 2.2 kg-m, 10 - 16 ft-Ib)
Fig. 17
L3476