Subaru XT 1988 Service Manual page 1236

6-2
ARRIVE
~~
D='
~ ~
0.:,
D»~~
Fig.
32
Display
Display range
Function
Display of ARRIVE
Resetting
BODY ELECTRICAL SYSTEM
ARRIVE
L6·1266
• The distance left to go is shown by four digits of the 7·segment figures. While the distance is
being displayed, the IAR R Ivel button on the control unit is illuminated. "0" as a high-order
digit is indicated by a blank, except when resetting.
• Same as the display range of the TR IP function.
• The distance left to go is displayed when the ARRiVe button is depressed.
• After presetting, count down in units of 0.1 starts.
• The IARR IVE I display illuminates for six minutes when "0.0" has been reached, then
extinguishes. The display also goes out when the ignition switch is turned to OFF; and will
not reilluminate when the switch is turned to ON again.
The I ARRIVE I display illuminates even if another function is being displayed. At the same
time, the buzzer turned to sounds for 3 seconds.
• While the ignition switch is turned to ON, counting continues if the other function button
is depressed.
• The count decreases by 1.0 km each time 637.5 x 4 pulses are applied.
• The count decreases by 1.0 mile each time
lQ20
x 4 pulses are applied.
• The indication immediately after connecting the battery is undefined.
1) The resetting function is attained when "100", "10", "1" or "0.1" switches are depressed
while the ARRiVe function is selected. This mode is cancelled 10 seconds after operating
these switches, or when the AR RIVE button is depressed.
2) No counting of ARRIVE function is performed during the resetting mode.
3) When resetting, counted contents less than 0.1 are cleared.
4) The "100", "10", "1" or "0.1" switches function independently, and no carrying over is
made at any digit position.
5 - 6 - - - 9 - 0 - 1 - 2 - - - - - -
L T h e upper digit remains unchanged.
5) When the "100", "10", "1" or "0.1" switch is held in, the displayed number changes in
sequence for each 0.5 second for the first 1.5 second period, and for each 0.25 second
afterward. The number increases by one when the switch is depressed once.
26