Subaru XT 1988 Service Manual page 1130

DOORS AND WINDOWS 5-2
Door Glass
Construction ...... Adjusting Position and Value
200081
~1!=,===~~~~~~S"b~;':~:N.
Unit: mm (in)
Fig. 29
Door Window Alignment
Before adjusting door window alignment, raise window until
weatherstrip at the end of gusset and glass edges are aligned
with each otheL
Adjusting bolts used for stabilizer, upper stoppers, sashes, etc.,
should be loosened before window alignment.
1) Temporarily tighten bolt located at the lower end of
regulator rear sash in the center of oblong hole on panel.
2) Temporarily tighten one of two bolts used to hold upper
end of regulator rear sash at the center of oblong hole on
panel. (The other bolt should be loose.)
Bolts used to hold upper and lower ends of front sash should
be tight.
Fig. 30
Temporarily tighten
(Center of oblong hole)
LS-280
15
I\~GI."I
LS-279
3) Raise window near the fully-closed position. With the
window held in that position, apply a force of approximately
20 N (2 kg, 4 Ib) to the upper edge of glass from the inside,
contact stabilizer on glass and hold it securely.
No clearance
L5-281
Fig. 31
Be sure there is no clearance between glass and stabilizer.
Do not press stabilizer against glass too hard. This
will
increase
the effort required to operate regulator.