Subaru XT 1988 Service Manual page 1053

\
i
AIR CONDITIONING SYSTEM
4-7
Cover end (F)
L4-569
Fig.
54
Install the cover end (F) so that the terminal, when installed
the coil, will face the same side as the shell inlet port.
(5) Attach the front cover tightener using FRONT
COVER TIGHTENER (926170000).
Remove dirt and other foreign matter from the tapered surface
at the end of the cover end (F).
(6) Install the shell packing.
a. Coat the packing with oil.
b. If the packing is protruded, re-adiust its position.
(7) Insert the shell.
Shell
L4-1545
Fig. 55
a. Install the shell so the oil reservoir of the cylinder will be
L4-1546
Fig.
56
b. After installing the shell, turn the assembly upside down by
holding the shaft.
2) Assembling cover end (R)
(1)
Fit the knock pin into the knock pin hole of the
cylinder ASSY.
(2) Install the 12 mm O-ring, SV plate and cylinder head
(R) in this order.
Fig.
57
L4-1548
at the lower portion.
Fig. 58
31