Subaru XT 1988 Service Manual page 1160

5-3 SEATS, SEAT BELTS, AND INTERIOR
OPERATION CHECK
Perform operation checks before installing new parts.
1) Temporarily install ELR ASSY under center pillar. Check
that lap belt reels in and out properly.
2) Gradually tilt ELR ASSY. Check that ELR locks so that
lap belt cannot be withdrawn when ELR is tilted 45° or more
in relation to standard installation angle, and that E LR
unlocks when it is tilted within 15°.
L5-734
Fig. 44
Rear Seat Belt
REMOVAL
OUTER BELT
1) Remove rear cushion and rear back rest.
2) Remove rear quarter upper and lower trim panel.
3) Remove outer anchor bolt and outer belt.
INNER BELT
1) Remove rear cushion.
2) Remove inner anchor bolt and inner belt.
INSTALLATION
Installation is in the reverse order of removal.
a. Remove anchor bolts, washers, spacers, etc. as a unit.
b. Be careful not to twist belts during installation.
c. Do not confuse outer and center buckles during installa·
tion. Although they look alike, they are not interchangeable.
18
h
Must be installed with installing
surface facing downward.
(Align with rotating stopper
.Q
stepped portion.)
'-
~~
W·.
Must be installed parallel
to vehicle center line
with installing surface
~ng
downw"d
LS-30S
Fig. 45
Console Box
REMOVAL
1) Remove front seats.
2) Apply hand brake lever.
3) Remove console cover and disconnect connector of
cigarette lighter.
4) Remove clips from tray and detach tray.
Tray
L5·306
Fig. 46