Subaru XT 1988 Service Manual page 913

,
STEERING SYSTEM
4-3
2) Shaft 3) Cartridge ASSY
(1) Apply grease to oil seal and front body internal (1) Install cam, rotor and vanes, in that order.
surfaces. (2) Insert pin into hole in cam, and insert cartridge ASSY
Make sure that the front body internal surfaces are free from
damage.
(2) Using INSTALLER (926970000), press-fit oil seal
into front body.
a. Orient oil seal toward correct direction.
b. When press-fitting, use care to prevent damage to surface
mating with rear body_
INSTALLER
(926770000)
Front body
Fig. 171
Press
{}
Oil seal
L4-1235
(3) Using GUIDE (926980000), install bearing onto
shaft.
Install retaining ring on oil seal. Insert shaft & bearing
ASSY into place, and lock with retaining ring.
(4) With pulley side of front body facing down, install
two types of O-rings, pressure plate and shaft on front
body, in that order.
Always use new O-rings.
After installation, make sure that shaft is inserted flush with
GUIDE (926830000) end face.
GUIDE
(926980000)
Shaft &
bearing ASSY
Fig. 172
Front body
L4-1242
into pressure plate.
a. Make sure vanes are installed with R marks facing the cam.
b. Check that vanes move smoothly.
c. Apply a coat of DEXRON ATF to vanes.
Vane
L4-1236
Fig. 173
4) Rear body
67
(1) Align pin with hole in rear body using a gasket, and
install rear body.
(2) First tighten all bolts in a criss-cross fashion to one-
half of specified torque, then to the specified torque.
Tightening torque:
49, - 59 N·m (5.0 - 6.0 kg-m, 36 - 43 ft-Ib)
Fig. 174
a. After tightening the rear body, make sure shaft turns
smoothly by hand.
b. Always use new O-rings.