Subaru XT 1988 Service Manual page 734

4WD SYSTEM
3-4
Each shim, which is installed to adjust the side bearing preload,
should be kept together with its mating retainer.
Fig. 36
ATTACHMENT
(398457700)
Side bearing retainer
(6) Pu II out differentia I case.
o
L3-458
Be careful not to permit the teeth to contact the case.
Fig. 37
(7) When replacing side bearing, pull bearing cup from
side bearing retainer.
1 PULLER ASSY
(398527700)
2 Bearing cup
Fig.
38
A14-015
21
(8) Extract bearing cone with PULLER SET
(399527700).
a. Set Puller so that its claws catch the edge of the bearing
cone.
b. Never mix up the right and left hand bearing cups and
cones.
Do not attempt to disassemble the parts unless necessary.
L3-460
Fig.
39
(9) Remove drive gear by loosening drive gear bolts.
Differential case
Drive gear
L3-461
Fig. 40
(10) Drive out pinion shaft lock pin from drive gear side.
The lock pin is staked at the pin hole end on the differential
case; do not drive it out forcibly before unstaking it.
,
.
,