Subaru XT 1988 Service Manual page 1132

DOORS AND WINDOWS
3) If al ignment is not made properly by means of upper
adjuster alone, move lower adjuster as required.
Fig. 35
Adjuster under
sash
Wide
Narrow
4) When any of the following problems (shown in figure
below) occur even when glass edge is parallel to weatherstrip,
move regulator sash forward or backward until alignment is
correct.
Fig.
36
:::: Wide or narrow
Loosen upper and lower
adjusters fully, and move
regulator rear sash
foreward or rearward.
5) After proper alignment, check to be sure glass edge fits
correctly into roof weatherstrip on the front pillar side.
IN
OUT
Be sure glass edge fits correctly
into roof weatherstrip.
Fig. 37
6) Tighten upper stoppers.
17
5-2
Wide
L5-285
•
L5-727
L5-287