Subaru XT 1988 Service Manual page 1256

6-2
BODY ELECTRICAL SYSTEM
Supporter
~
Antenna mounting nut
Feeder socket
Bracket
Fig. 71
Harness connector
Taping
Tube protrusion:
approx. 20 mm (0.79 in)
Grommet
INSTALLATION
1) Connect feeder socket and harness connector.
L6-1502
2) Pass antenna rod through mounting hole. Temporarily
tighten antenna bracket with two bolts. Install supporter and
tighten antenna mounting nut.
3) Tighten two bolts to secure antenna bracket.
4) Pass drain tube through grommet. Be sure tube protrudes
approximately 20 mm (0.79 in).
REPLACEMENT
ANTENNA ROD
Removing antenna rod
1) Loosen antenna mounting nut enough so that it can be
removed with your fingers.
2) Turn radio power switch ON and extend antenna. Remove
antenna mounting nut.
3) Hold the lower section of antenna rod by hand and lift
antenna rod vertically. Extract inner pipe and rope from
antenna housing.
46
Fig.
72
Installing antenna rod
~1'
Antenna mounting
nut
LS-899
1) Insert centering pipe (furnished with an antenna rod of
genuine parts) into antenna housing until it bottoms.
LS-900
Fig. 73
2) Insert antenna rod rope into antenna housing via centering
pipe with its rack facing outward; at the same time, turn radio
power switch OFF.
Be sure antenna rod is vertical to antenna housing. This
prevents rack from sustaining damage and makes it easy to
insert rope.
3) Remove centering pipe from antenna housing and detach
it from rope.
Rack
L6-901
Fig.
74
I