Subaru XT 1988 Service Manual page 914

4-3 STEERING SYSTEM
5) Spool Valve ASSY
(1)
Install spring into front body. Then, with spool valve
ASSY dipped in specified hydraulic oil, install it into the
front body.
L4-1239
Fig. 175
(2) Using a 5-mm-dia. round bar, ensure that valve moves
smoothly.
(3)
Set O-ring, with grease applied to it, onto connector
and secure connector to front body.
Tightening torque:
29 - 39 N·m (3.0 - 4.0 kg-m, 22 - 29 ft-Ib)
a. Use care to prevent damage to D·ring at installation.
b. When tightening connector, ensure that D'ring does not
protrude or get caught.
L4-1238
Fig. 176
6) Check
(1) When reassembly procedures have been completed,
turn shaft by hand to ensure it turns smoothly. If it binds
or other unusual conditions are evident, disassemble again
and check for foreign matter trapped on sliding surfaces
and improper installation. Eliminate the cause of trouble.
(2) Check followings by referring to "CHECK" article.
• Excessive play in pulley shaft
• Ditch deflection of pulley
• Resistance to rotation of pulley
• Measurement of generated oil pressure
INSTALLATION
1)
Install bracket on engine.
Tightening torque:
18 - 22 N·m (1.8 - 2.2 kg-m, 13 - 16 ft-Ib)
2)
Install oil pump on oil tank as follows outside the vehicle:
Prior to installation, make sure that all oil is removed from oil
pump, oil tank and pipe.
(1)
Connect pipe E to oil pump.
Tightening torque:
10 - 20 N·m (1.0 - 2.0 kg-m, 7 - 14 ft·lb)
Use two wrenches, one on the pump side and the other on
pipe E, to tighten the pipe at the specified degrees to the
center line of the pump shaft.
L4·361
Fig. 177
68