Subaru XT 1988 Service Manual page 904

4-3
STEERING SYSTEM
5) Attach GUIDE (926250000) to rack ASSY which
protrudes beyond the cylinder side, and apply a thin coat of
grease uniformly to the surfaces of rack ASSY and GU IDE.
r
GU I DE (926250000)
*--~~-
-
-~---
-
-~~
- - - - - - - ----- - ---
'X 'X )( , )( 'X )( " 'X ')( X " X 'X "
I
~
Grease
L4-462
Fig. 144
6) Apply coat of grease to the inner surface of holder ASSY
and a-ring, insert into rack ASSY, and attach holder ASSY to
steering body ASSY.
a. Be sure GUIDE is free from scratches which would damage
V-packing.
b. Be careful not to damage the lip section of Y -packing when
installing holder ASSY.
-+----------------------
L4-463
Fig. 145
7) Apply a coat of grease to snap ring and insert it into
groove to secure holder ASSY.
Be sure one end of snap ring is close to pin hole.
58
Si d "
'"'P
no~,--
__ _
lb
lEa)
- - - -
- - - - -
-
------
- - - - -
-
I ~ __ :
'--L-LrJj_
~'-----_/
L4-464
Fig. 146
8) Attach INSTALLER (926320000) to the cylinder side of
rack ASSY and drive back·up ring and oil seal into place on
steering body ASSY using a pressing tool.
Be sure to push INSTALLER until its groove reaches the end
surface of holder ASSY.
Steering body ASSY
Backup ring
----+--I--~
- - - - -
----+--.
Rack ASSY
L4·465
Fig. 147
INSTALLATION OF VALVE ASSEMBLY
1) Clean all traces of sealer, oil, rust, etc. from the mating
surface of valve housing and steering body ASSY.
2) Attach shim(s) to the stepped lip of steering body ASSY's
pinion housing, and apply sealer (Fuji Bond C: 004403004)
uniformly to the lip side end surface of pinion housing.
a. Use the same number of shims as before if previopsly re-
moved steering body ASSY, valve housing and valve ASSY are
reassem bled.
b. If any of the above units are replaced with new ones, add a
number of shims, install valve ASSY to pinion housing, and
tighten two socket bolts to the specified torque of 20 to 29 N·m
(2 to 3 kg-m, 14 to 22 ft-Ib). Next, measure the clearance at the
mating surface of steering body ASSY and valve housing with
a thickness gauge. Remove the number of shim(s) which
correspond to the clearance.