Subaru XT 1988 Service Manual page 1159

SEATS, SEAT BELTS, AND INTERIOR
5-3
Manual Lap Belt
Outer Belt Assembly
REMOVAL
1) Remove belt holder cap and remove either front or rear
screw from belt holder.
L5-672
Fig. 40
Inner Belt Assembly
REMOVAL
1) Push emergency release button on the shoulder anchor
and remove belt.
2) Remove belt stopper. Remove shoulder belt from belt
guide and reel it until its end reaches outlet hole in console
box.
3) Remove front seats. (Disconnect belt warning connector
located under driver seat.)
Fig. 42
2) Remove tongue from belt and reel the entire belt into 4) Remove anchor nut and inner slide rail as a unit. (On
ELR. driver seat, also remove tape which secures harness.)
3) Move front seat to the extreme front position and remove
anchor bolt and screw.
L5-673
Fig. 41
INSTALLATION
I nstallation is in the reverse order of removal.
17
Fig. 43
INSTALLATION
Installation is in the reverse order of removal.
a. The left and right ELR's are not mutually interchangeable
because different sensors are used.
b. On inner belts, be sure to insert pin into position-limit
guide hole.