Subaru XT 1988 Service Manual page 631

3-2
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
~
Disassembly, Inspection
and Assembly of Each
Component
1. Reduction Drive Gear Assembly
DISASSEMBLY
1) Take out the seal rings.
Be careful not to damage the seal rings.
L3-576
Fig.
168
2) Take out the snap ring (out).
Be careful not to damage the splines.
3) Using a press, remove the reduction drive gear.
Reduction drive gear
4) Using a press, remove the ball bearing.
Reduction drive shaft
Ball bearing
L3-578
Fig. 170
INSPECTION
Make sure that each component is free of harmful gouges,
cuts, or dust.
ASSEMBLY
1) Press-fit the ball bearing and reduction drive gear to the
shaft.
Reduction drive gear
Ball baaring
Reduction drive shaft
L3·579
Fig. 171
2) 4WD: Fit the snap ring securely in the snap ring groove
on the shaft.
FWD: Press-fit the ball bearing using a press, then fit the snap
L3-577
ring to the snap ring groove on the shaft.
L-
F
-
i9
-_
- 1 6 - 9 - - - - ' - - - - - - - - - - - - - - - . . . J
3) Attach two seal rings.
To make subsequent assembly easier, apply vaseline to the
grooves of the shaft and to the exterior of the seal ring.
104
I