Subaru XT 1988 Service Manual page 655

3-2
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
15) Assemble the rear internal gear.
(1) Join the thrust needle bearing* and thrust washer to
the gear with vaseline, and install the gear while rotating
it.
(2) Securely engage the bearing with the dog of the over-
running clutch hub.
Installation is complete when the snap ring top surface of the
forward clutch drum recedes approximately 3.5 mm (0.138
in).
3.5 mm (0.138 in)
Overrunning clutch hub
Rear internal gear
bearing
L3-749
Fig_ 248
16) Install the rear planetary carrier.
Attach the thrust needle bearing * to the inside of the carrier
with vaseline. Then install the carrier while rotating slowly.
L3-750
Fig.
249
17) Install the rear sun gear.
Install the gear with the oil hole facing up.
128
~
Front
L3-751
Fig. 250
18) Install the front planetary carrier.
Attach the thrust needle bearings * to both sides of the carrier
with vaseline. Install the carrier carefully, while aligning with
the splines of the forward clutch drum, and while rotating the
pinion.
Forward clutch
drum
Fig. 251
19) Install the front sun gear.
Front planetary
carrier
L3-752
Attach the thrust needle bearing * to the gear, and install the
gear while turning slowly.
L3-753
Fig.
252