Subaru XT 1988 Service Manual page 416

2-11
ENGINE AND TRANSMISSION MOUNTING SYSTEM
INSTALLATION
Install transmission to engine and temporarily tighten engine to transmission nuts.
Install rear cushion rubber and rear crossmember.
Tighten engine to transmission nuts on the lower side.
Remove transmission jack.
Remove special tool.
I
Install axle shaft to axle drive shaft.
I
t
I
•
Install transverse link temporarily to front crossmember .
I
• Temporarily install stabilizer to transverse link.
,
I
Lower car to floor.
I
t
I
Tighten transverse link·to·front crossmember mounting bolt and
I
transverse link·to·stabilizer mounting bolt.
t
I
Install gear shift system.
I
(4WD)
•
I
Install propeller shaft.
1
(AfT)
•
I
Connect oil cooler hoses.
1
I
Connect engine and transmission.
1
,
I
Install pitching stopper and bracket.
l
(AID
•
I
Install and tighten torque converter mounting bolts.
I
Connect hoses, harness connectors and cables.
I
~
I
Install exhaust system (front exhaust pipe).
I
~
I
Connect ground cable to battery and transmission side.
I
~
I Check transmission oil level.
I
•
I
Check
ATF with engine idling
I
t
I
Start engine and recheck oil level.
1
This flowchart shows the main procedures for removing and installing the transmission and its related parts. For details, refer to
the text.
8