Subaru XT 1988 Service Manual page 430

2-11
ENGINE AND TRANSMISSION MOUNTING SYSTEM
16) Disconnect axle shaft from drive shaft on each side. 17) Remove engine-to-transmission mounting nuts.
(1) Loosen upper bolt and nut from plate which secures
transverse link to stabilizer, and remove lower bolt.
Separate transverse link and stabilizer.
L
L
\_-
l
I-
e
l
t
Fig. 39
I
'---_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ --=L:.::..2._14_6--..J2
18) Disconnect oil cooler hoses. (AIT)
Fig. 37
(2) Remove hand brake cable bracket from transverse
link",
(3) 'Remove bolt holding transverse link to crossmember
on each side.
(4) Lower transverse link.
(5) Remove spring pin and separate axle shaft from drive
shaft on each side.
Place a container to catch oil.
Fig. 40
19) Place transmission jack under transmission.
Always support transmission case with a transmission jack.
Do not place support under oil pan; otherwise oil pan may be
damaged. (A/T)
Fig. 38
a. Use REMOVER 2 (398791700) to remove spring pin.
b. Discard old spring pin and install new one.
Transmission jack
C.
Be sure to remove axle shaft from drive shaft by pushing L2·1177
the rear oftire outward.
Fig. 41
22