Subaru XT 1988 Service Manual page 1155

SEATS, SEAT BELTS, AND INTERIOR
5-3
3) Pass rear seat belt through slit at rear section of rear
cushion.
INSTALLATION
Installation is in the reverse order of removal.
Trim Cushion And Trim Back
(1800cc DL model)
REMOVAL
\\,--'-""~---
'--_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ =L2:..:-2:.:9:::..J9 1) Remove bolts which hold front of trim cushion to floor.
Fig.
24
2)
Slightly raise front side of trim cushion and push center
rear section down. With trim cushion held in that position,
move it forward unti I it is unhooked.
4)
Fold seat back rest forward and remove bolts which hold 3) Remove caps from upper section of trim back, using a
hinge to the right side of backrest. standard screwdriver, and remove screws.
Fig.
25
5) Tilt rear seat backrest [approx. 400 mm 115.75 in)] for·
ward and slide it toward the right until it can be detached
from the left bracket.
Fig. 26
About 400 mm (15.75 in)
t
"I
'\
\'
.\
\'
,
\
~
L5-378
4) Lift trim back up and remove.
Trim back
Hook
Trim cushion
Fig.
27
INSTALLATION
Installation is in the reverse order of removal.
13
L5·379