Subaru XT 1988 Service Manual page 708

3-3
TRANSMISSON CONTROL SYSTEM
(3) After assembling, check that the lever moves smooth·
Iy.
(4) Mount the cushion rubber on the stay CPo
Tightening torque:
Stay CP to cushion rubber
9 - 15
N·m
(0.9 - 1.5
kg-m,
6.5 - 10.8
ft-Ib)
6) Mount the following parts on the rod CP both sides.
CD
Bushing (Rubber)
®
Bushing (Nylon)
@
Spacer
(1) Apply grease [SUNLIGHT No.2 (003602010) or
equivalent] to the inner and side surfaces of the bushings
when installing the spacers.
(2) Mount the chrome·plated (silver) spacer at the lever
end and the galvanized (yellow) spacer at the transmission
end.
(3) The rod should be installed in the direction shown in
the figure below.
FRONT
o
Fig. 18
7) Connect the rod CP to the lever.
Tightening torque:
9 - 15
N·m
(0.9 - 1.5
kg-m,
6.5 - 10.8
ft-Ib)
Rocking torque:
2.7
N·m
(0.28
kg-m,
2.0
ft-Ib) or lower
Rocking torque
L3492
8) Check that there is no excessive play and that the parts
move smoothly.
INSTALLATION
1) Mount the rod CP at the joint on the transmission.
• Insert the bolt from the lower side.
Tightening torque:
9 - 15 N'm (0.9 - 1.5 kg·m, 6.5 - 10.8 ft-Ib)
2) Mount the bracket CP on the transmission.
Tightening torque:
14 - 22
N:m
(1.4 - 2.2
kg-m,
10 - 16
ft-Ib)
3)
Mount the gearshift lever ASSY on .the body.
Tightening torque:
14 - 22 N·m (1.4 - 2.2 kg-m, 10 - 16 ft-Ib)
4)
Mount the spring between joint CP and bracket CPo
For FWD models, the hook shape of the spring differs at each
end. The longer hook end should be attached at the joint
CPo
5) Connect the connector for 4WD switch. (Selective 4WD)
6) Install the console box. (Selective 4WD)
7) Check that the lever moves smoothly.
8)
Install the exhaust pipe (rear).
Automatic Transmission
REMOVAL
1) Remove the cable ASSY.
(1) Separate cable from transmission lever.
L3477
(2) Remove cable clamp from transmission case.
~----------------------------------------~
Fig. 19
10