Subaru XT 1988 Service Manual page 730

4WD SYSTEM
3-4
8) Fit a new oil seal.
A14-008
Fig_ 26
9) Install companion flange_
10) Tighten self-locking nut within the specified torque range
so
that the turning resistance of companion flange becomes
the same as that before replacing oil seal.
Torque (Drive pinion nut):
167 - 196 N'm (17.0 - 20.0 kg-m, 123 - 145 ft-Ib)
11) Reassembling procedure hereafter is the reverse of the
disassembling.
REPLACING SIDE OIL SEAL
1) Remove two bolts which fix the upper portion of shock
A16-180
Fig.
27
6)
Detach BJ from spindle of trailing arm with trailing arm
lowered fully and detach DOJ from differential spindle and
then remove drive shaft
ASSY_
7)
Loosen differential spindle set bolt by using WRENCH
(925560000) and remove spindle with packing.
8)
Remove oil seal.
PULLER ASSY (398527700)
~
A14-010
Fig.
28
absorber to the body in unladen condition_
9) Drive in a new oil seal with DR I FT (398437700)
2) Loosen both wheel nuts.
3) Jack up the vehicle and support it with rigid racks_
Apply chassis grease between the oil seal lips.
4) Remove wheels.
5) Drive out spring pins of BJ and DOJ by using 6 mm 10) Reassembling procedure hereafter is the reverse of the
(0.24 in) diameter of steel rod.
disassembly.
17