Subaru XT 1988 Service Manual page 710

3-3
TRANSMISSON CONTROL SYSTEM
3) Remove selector lever installing bolt and detach the boot
by pushing it from underneath, then disconnect the selector
lever from plate CPo
Do not remove the bushings from selector lever.
2) Confirm the following parts for operating condition
before assembly.
(1) Sliding condition of the button in the grip ... they
should be moved smoothly.
(2) Insertion of the grip on the selector lever ... When
pushing the grip on selector lever by hand, the screw holes
should be aligned in line.
(3) Operation of the selector lever and rod ... they should
be moved smoothly.
(4) Insertion of the spacer into the selector lever ... it
should be inserted lightly by fingers.
ASSEMBLY
1) Clean all disassembled parts.
2) Assemble rod to selector lever.
A 19.027
(1) Apply grease on both sliding part ends of rod and
L..F-ig-.-2-5--------------------=-..:...=.....J
spring, then insert them into selector lever.
4) Install the grip and button to the selector lever tempo-
rarily, and drive the spring pin out from rod, taking care not
to make damage on connected parts.
•
Fig. 26
Selector leVer\
Rod
INSPECTION
Load
•
Rod
-.j~- [3.5 - 3.8 mm
(0.138 -0.150 in) dia.l
/
Spring pin
L3-483
1) Inspect the removed parts by comparing with new ones
for deformation, damage and wear. Correct or replace if defec-
tive.
CD
Rubber bushing
CV
@
@
®
®
(J)
@
Selector lever rod
Boot
Plate CP
Spring
Button
Grip
Indicator ASSY
Apply grease
Selector lever
L3-484
Fig. 27
12
(2) Match the oblong hole of selector lever and the spring
pin hole of rod.
(3) Press the spring pin into the selector lever and rod
from side opposite arm.
In order to prevent the spring pin from contacting with
the guide plate of plate CP, stop the spring pin at the same
level of selector lever outer surface as shown in figure.
Rod
Spring pin
. . Press
: 0
: : ---------Selector lever
o
0
Arm
L3-485
Fig. 28
I