Subaru XT 1988 Service Manual page 1137

5-2
DOORS AND WINDOWS
a. Primer is hard to wipe off body paint, instrument panel,
inner trim, etc. if dropped on them. So put masking on them.
b. After application, 1st primer will dry spontaneously for
about 10 minutes.
c. Do not touch primer-coated surface under any circum-
stances.
8) Application of adhesive.
(1) Cut nozzle tip of cartridge as shown in figure below.
(2) Open cartridge and put it into a gun with nozzle
attached.
(3) Apply adhesive uniformly to all sides of adhesion
surface while operating gun along glass end face.
Apply adh.esive
while building it up
~
10.47 to 0.591.
10 (0.39)
A-~
~
15 (0.59)
Cut off nozzle tip
Unit: mm (in)
L5·226
Fig.
45
9) Installation of glass.
(1) Hold glass with rubber suction cups.
(2) Mount glass on body with matching marks aligned.
(3) Stick them fast by pressing all sides lightly.
L5·227
Fig. 46
10) Installation of moulding.
(1) Remove adhesive overflowing outside of glass until it
becomes level with outer height of glass. Then, add
adhesive to portions that need it.
L5·228
Fig.
47
(2) Insert mouldings into corner parts, and then put them
into slits in body.
(3) Press·fit mouldings.
(4) Remove overflowing adhesive with a spatula, and
clean with alcohol or white gasoline.
a. Install mouldings with proper facing_
Glassend •
• Body end
L5-729
Fig. 49
22
b. Do not open and close door after mouldings have been
installed. When opening and closing door for unavoidable
reason, lower door glass and gently move door.