Subaru XT 1988 Service Manual page 628

AUTOMATIC TRANSMISSION AND DIFFERENTIAL 3-2
(3) Take out the low & reverse piston by applying com-
pressed air.
L3-561
Fig. 153
26) After removing the snap ring (inner), take out the servo
piston by applying compressed air from the release pressure
side.
Hold the servo piston with a rag so that it will not be ejected
with the air pressure. In this case, do not allow your finger to
be pinched between the pipe and retainer.
Fig. 154
27) Apply compressed air from the operating pressure side,
and take out accumulator (3-4), accumulator (1-2), accumu-
lator (2-3), and accumulator (N-D).
101
Fig. 155
28) Remove the range select lever.
29) Remove the detent spring.
L3-564
Fig. 156
30) Remove the parking rod together with the manual lever.
Then remove the manual shaft by pulling off the straight pin.
Be careful not to damage the lips of the press-fitted oil seal in
the case.
Fig. 157