Subaru XT 1988 Service Manual page 923

STEERING SYSTEM
4-3
8) Using a screwdriver, drive oil seal out of front body.
INSPECTION
Fig. 204
~
1111[011
~
11(0110
~
(fillOIl
L:
Fig. 205
No.
Part Name
1. Front body
2. Rotor
3. Vane
4.
Cam ring
5.
Pressure plate
6. Rear body
7.
Motor
Perform following inspection procedures and repair or replace
defective parts.
L4-1430
Pressure plate
~Q
[ , " O"ring
Oil seal
L4-1441
Description Remedy
1) Damage on body surfaces
Replace with a new one.
2) Wear and damage on sliding surfaces
1) Wear and damage on sliding surfaces
2) Ridge wear on vane sliding grooves (If light leaks
with vane in slit against light source)
If damage is serious, replace with
Excessive wear on nose radius and side surfaces
a new cartr idge ASSY.
Ridge wear on sliding surfaces
Wear and damage on sliding surfaces
Replace with a new one.
1) Damage on body surfaces
Replace with a new one.
2) Wear and damage on sliding surfaces
Wear or damage on contact surfaces of oil seal and
Replace with a new one.
shaft
77