Subaru XT 1988 Service Manual page 1200

ENGINE ELECTRICAL SYSTEM 6-1
ASSEMBLY
To reassemble, reverse the disassembly procedure, noting the
following points.
1) Use a high temperature solder for soldering the diode and
stator coil leads, and the diode lead and brush holder.
Observe the following working conditions:
Soldering iron temperature 300 to 380°C (572 to 716° F)
Soldering time : Within 5 seconds
Solder : Pb-Sn (5-1) solder
2) Assembling of front side and rear side
(1) Whenever the alternator has been disassembled, be
sure to replace the rear side ball bearing.
(2) The rear side bearing has a ring inserted into the
offset groove of the outer race, and a part of the ring is
projected to the outside of the outer race. When reassem-
bling, rotate the ring so that this projection is minimized.
If any fault is found on the rear cover bearing portion,
replace the rear cover.
Ring
Eccen tric groove
E6-066
Fig. 39
19
(3) Insert a pin from outside the rear cover to push each
brush into the brush holder.
After completely reassembled, be sure to remove the pin.
Pin
L6-375
Fig. 40