Subaru XT 1988 Service Manual page 831

4-2
WHEELS AND AXLES
Be sure to insert (press) hub
&
disc ASSY onto axle shaft until
the end surface of hub contacts ball bearing.
If the ASSY is hard to press, rotate it to locate the point
where it is easily pressed.
8) Install disc brake ASSY to housing by two bolts.
Tightening torque:
49 - 69 N·m (5.0 - 7.0 kg-m, 36 - 51 ft·lb)
L4·101
Fig.
22
9) Connect parking brake cable to brake ASSY.
L4·036
Fig. 23
10) Apply parking brake.
11) Fit center piece, washer spring and castle nut in this order
onto axle shaft and tighten castle nut to the specified torque,
then insert a new cotter pin and bend it around castle nut.
After tightening the nut to the specified torque, retighten
further within 30
0
until a slot of the castle nut is aligned to
the hole in the axle shaft.
Tightening torque:
196 N·m (20 kg-m, 145 ft-Ib)
16
~aint mark
Nut side
.~.
Center piece side
Washer spring
Fig. 24
12) Install wheels and wheel caps.
13) Put down vehicle from rigid racks.
1 Cotter pi n
2 Castle nut
3 Washer spring
4 Center piece
A16·197
14) Connect ground cable with negative terminal of battery.
Housing (XT6)
REMOVAL
1)
Remove cotter pin and castle nut which secure tie-rod end
ball joint to housing knuckle arm.
2)
Using a puller, disconnect tie rod end ball joint from
housing knuckle arm.
3) Remove 10-mm bolt. Extract trasverse link ball joint
from houisng.
4)
Remove two bolts which connect housing and damper
strut, and disconnect strut from housing.
Fig. 25