Points To Note When Installing The Rail Unit (Inner Finisher-H1) - Canon imageRUNNER ADVANCE C5560 Series Troubleshooting Manual

Copier Color | iR-ADV C5560/C5550/C5540/C5535 Series | imageRUNNER ADVANCE C5535, imageRUNNER ADVANCE C5535F,
imageRUNNER ADVANCE C5535i, imageRUNNER ADVANCE C5540, imageRUNNER ADVANCE C5540F, imageRUNNER ADVANCE
C5540i, imageRUNNER ADVANCE C5550, imageRUNNER ADVANCE C5550F, imageRUNNER ADVANCE C5550i, imageRUNNER
ADVANCE C5560, imageRUNNER ADVANCE C5560F, imageRUNNER ADVANCE C5560i

Points to note when installing the rail unit (Inner Finisher-H1)

For CE
[Symptom]
When installing the rail unit to the inner finisher [1], the frame of the finisher would be twisted if a downward force is applied to
the area shown with the arrow while the finisher is faced upside down.
When a gap is created between the front end plate and the back end plate due to twist on the frame, the craw [3] of the molded
part [2] may come off.
Fig. [A] is the normal state and Fig.[B] is where the craw of the molded part [2] came off.
[Service work]
When the craw of the molded part is off, install the rail unit after placing the craw of the molded part back in the correct place by
firmly pressing the area shown with the arrow.
14