Mitsubishi Electric GOT2000 Series Connection Manual page 1213

■6. When the FA transparent function is used in a bus connection
(1) When multiple GOTs are bus-connected
When multiple GOTs are bus-connected, the FA transparent function can be used on each GOT.
However, note that the monitoring performance of each GOT slows down as the number of monitoring GOTs and
personal computers increases.
(2) When the FA transparent function is used in a bus connection
When the FA transparent function is used in a bus connection, the following GX Works2 functions cannot be
executed.
The message [The executed function is not supported. Please check the manual and other documentation.] is
displayed on GX Works2.
• Remote Reset
• Remote system reset
• Remote RUN
• Remote STOP
• Remote PAUSE
• Remote STEP-RUN
• Remote latch clear
• Write clock data
• Clear malfunction log
■7. When PLC power disconnection occurs with the FA transparent function being used
While the FA transparent function is being used, if the communication between the PLC and the GOT is stopped due to
PLC power disconnection or a disconnection of the communication cable between the PLC and the GOT, the GOT
waits for timeout against the communication request from the peripheral devices (PX Developer, etc.), and it takes a
few minutes to recover the monitoring between the PLC and the GOT.
Unsupported functions
Online operation
PC
Inexecutable only when specify all stations/groups has been performed.
Monitoring
PX Developer and so on
Remark
―
22 - 157
22.8 Precautions
22