Table of Contents
Advertisement
On-Chip Peripheral Module Request Mode: In this mode a transfer is performed in response to
a transfer request signal (interrupt request signal) from an on-chip peripheral module. As shown in
table 14.5, there are seven transfer request signals: input capture interrupts from the timer unit
(TMU), and receive-data-full interrupts (RXI) and transmit-data-empty interrupts (TXI) from the
two serial communication interfaces (SCI, SCIF). If DMA transfer is enabled (DE = 1, DME = 1,
TE = 0, NMIF = 0, AE = 0), transfer starts when a transfer request signal is input.
The source of the transfer request does not have to be the data transfer source or destination.
However, when the transfer request is set to RXI (transfer request by SCI/SCIF receive-data-full
interrupt), the transfer source must be the SCI/SCIF's receive data register (SCRDR1/SCFRDR2).
When the transfer request is set to TXI (transfer request by SCI/SCIF transmit-data-empty
interrupt), the transfer destination must be the SCI/SCIF's transmit data register
(SCTDR1/SCFTDR2).
Rev. 3.0, 04/02, page 488 of 1064
Advertisement
Table of Contents
