•
Channel 7 (SH7751R only): Single or dual address mode. External requests are
accepted.
In DDT mode, data transfer is carried out by the SH7751 using the
K, ID [1:0], and D[31:0] signals to perform handshaking between the external
device and the DMAC, and data transfer is carried out by the SH7751R using the
,
,
external device and the DMAC.
Request-queue clear for each channel (SH7751R only)
Request queues can be cleared on a channel-by-channel basis in either of the following two
ways.
Clearing a request queue by DTR format
The request queues of the relevant channel are cleared when it receives DTR.SZ = 110,
DTR.ID = 00, DTR.MD = 11, and DTR.COUNT [7:4]* = [1–8].
Using software to clear the request queue
The request queues of the relevant channel are cleared by writing a 1 to the CHCRn.QCL
bit (request-queue clear bit) of each channel.
Note: * DTR.COUNT [7:4] (DTR [23:20]): Sets the port as not used.
, ID [2:0], and D[31:0] signals to perform handshaking between the
,
Rev. 3.0, 04/02, page 465 of 1064
,
,
,