Radius Group Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
R G
ADIUS ROUP
To activate the Radius Group mode, enter the aaa group server command at the Global Configuration
mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#aaa group server radius myServer
ProCurve(config-sg-radius)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
server [acct-port <port number>| auth-port <port number>]
5991-2114
C S
OMMAND ET
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Radius Group Command Set

on page 1431
on page 1426
1425