Deny Icmp - Dell Z9500 Command Reference Manual

ip access-list extended

deny icmp

To drop all or specific internet control message protocol (ICMP) messages, configure a filter.
Z9500
Syntax
deny icmp {source–ip—address mask | any | host ip-address}
{destination mask | any | host ip-address} [log] [dscp] [[count
[bytes]] [order] [monitor] [fragments]
To remove this filter, you have two choices:
•
•
Parameters
source-ip-
address
mask
any
host ip-address
destination
log
dscp
count
bytes
order
236
— creates an extended ACL.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny icmp {source–ip—address mask | any | host ip-
address} {destination mask | any | host ip-address} command.
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) Enter the keyword log to include ACL matches
in the log.
Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword bytes to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
Access Control Lists (ACL)