Common Ip Acl Commands - Dell Z9500 Command Reference Manual

Common IP ACL Commands

The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an ACL is created without a rule and then is applied to an interface,
ACL behavior reflects an implicit permit.
The Z9500 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the
clear counters ip access-group
Erase all counters maintained for access lists.
Z9500
Syntax
clear counters ip access-group [access-list-name]
Parameters
access-list-
name
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Access Control Lists (ACL)
Commands Common to all ACL Types
(OPTIONAL) Enter the name of a configured access-list, up
to 140 characters.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
section.
217