In And Out Button - Vodavi STARPLUS STSe Operation Manual

2-184
Features and Operation
Programming Steps
1. Press the IDLE SPEAKER MODE flexible button (FLASH 05, Button #10).
2. Enter a 0 or 1 that corresponds with the following entries:
[0] = First digit dialed is audible (Disabled)
[1] = First digit dialed is Muted (Enabled)
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... Idle Speaker Mode is disabled.

In and Out Button

Description
An In and Out Button will toggle a station from an in status to an out status and from an out
status to an in status. When in an out status, the LCD will display "OUT MODE" and all
incoming calls will forward to the Preset Internal Busy Forward destination (Flash 50/51,
Page C, Button #2). If no forwarding destination is programmed in Flash 50/51, the call will be
presented without forwarding.
Programming Steps
1. Press the IN AND OUT BTN flexible button (FLASH 07, Button #22). The following
message displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... In and Out button flash rate is set for a Red 120 ipm Flash (10).
Operation
Press the preprogrammed In and Out Button (feature code 644).
Conditions
»
Attendant stations and SLT stations do not have the In and Out feature capability.
STARPLUS STSe - Programming & Operations Manual
I D L E S PE A K E R MOD E
D I S A B LE D
I N AN D O UT BT N
R E D 1 2 0 I P M F L A S H
Table 2-16 on page 2-163).
In and Out Button
0-1
00-28
August 2005