Co Line Group Queuing - Vodavi STARPLUS STSe Operation Manual

CO Line Group Queuing

Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
4. Press the CO LINE GROUP flexible button (Button #8).
5. Enter a valid number on the dial pad (0-23) which corresponds to Groups 0-23.
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... All lines are placed in Line Group 1.
CO Line Group Queuing
Description
The CO Line Group Queuing feature allows trunk group queuing to be turned on (enabled) or
turned off (disabled) per group. This feature is used only in conjunction with LCR.
Programming Steps
1. Press FLASH and dial [39]. The following message displays:
2. Press button 1-24 to select desired CO Group (0-23) to be programmed. The following
displays:
STARPLUS STSe - Programming & Operations Manual
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
E N T E R B U T TO N N U MBE R
XXX-XXX = CO Line Range
L I N E GR O U P
1
CO L I N E GR O U P Q U E U IN G
E N T E R B U T TO N N U MBE R
G R O U P 1
E N AB LE D
Features and Operation
0-23
0-1
2-75
August 2005