ISDN Programming - Page B
Set-Up Timer
Description
The Set-up Timer setting establishes the response time to setup message. Do not change the
Set-up Timer setting unless advised to do so by Technical Support.
Programming Steps
1. Press the SET UP TIMER flexible button (FLASH 45, Page B, Button #11).
2. Enter a valid number (00-99 seconds) on the dial pad.
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... Set-up Timer setting is 10 seconds
Disconnect Timer
Description
The Disconnect Timer setting establishes the response time to a disconnect message. Do not
change the Disconnect Timer setting unless advised to do so by Technical Support.
Programming Steps
1. Press the DISCONNECT TIMER flexible button (FLASH 45, Page B, Button #12).
2. Enter a valid number (00-99 seconds) on the dial pad.
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... Disconnect Timer setting is 4 seconds.
Release Request
Description
Do not change the Release Request setting unless advised to do so by Technical Support.
Programming Steps
1. Press the RELEASE REQUEST flexible button (FLASH 45, Page B, Button #13).
2. Enter a valid number (00-99 seconds) on the dial pad.
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... Release Request Timer setting is 4 seconds.
STARPLUS STSe - Programming & Operations Manual
S E TUP TI ME R
T 3 0 3
1 0
D I S CON NE CT TI M ER
T 3 0 5
0 4
R E LE A S E RE Q U E S T
T 3 0 8
0 4
Features and Operation
00-99
00-99
00-99
2-207
August 2005