Table of Contents
Advertisement
2-10
Conference / DISA Timer
Programming Steps
1. Press the CONFERENCE/DISA TIMER flex button (FLASH 01,
2. Enter a valid number on the dial pad that corresponds to
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Conference/DISA Timer determines the time an unsupervised
conference can continue after the initiator of the conference has exited.
By default, the Conference/DISA Timer is set at 10 minutes and is variable
from 01–99 minutes. A 00 entry disables the timer and no automatic
disconnect occurs.
Paging Time-Out Timer
Programming Steps
1. Press the PAGING TIMEOUT TIMER flex button (FLASH 01,
2. Enter a valid number on the dial pad that corresponds to
Button #9). The following message displays:
CON FER EN CE T IMER
10
01-99 minutes.
display updates.
The Conference Timer also allows the system administrator to control
the time a DISA caller is allowed after establishing a Trunk-to-Trunk
call. At the expiration of the Conference Timer, a tone is presented to
both DISA parties, then one minute later the system automatically
releases both trunks.
The Conference Timer does not affect or control a DISA-to-Station call.
Button #10). The following message displays:
PAG ING TIME OUT
15
01-60 seconds.
0 0-9 9
0 0-6 0
System Timers
Advertisement
Table of Contents
