Calling Number; Loopback - Vodavi STARPLUS STSe Operation Manual

ISDN Programming - Page A
Nortel DMS 100 Only
1. Change Flash 45, button 10 (Numbering Plan) to CO by dialing 1 HOLD.
2. Set the definition in the DMS 100 Central Office Switch.
The DMS 100 Office refers to this switch as National or N12 Standard so they know
not to look at this parameter in their switch.
LTDEF should be set to NI PRI N12 V1.

Calling Number

Description
0 disables the calling party number from being sent to the CO. 1 will enable the calling party
number feature and the number will be sent to the CO.
Programming Steps
1. Press the CALLING NUMBER flexible button (FLASH 45, Page A, Button #11).
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... Calling Number is enabled.

Loopback

Description
Do not change the Loopback setting unless advised to do so by Technical Support.
Programming Steps
1. Press the LOOPBACK flexible button (FLASH 45, Page A, Button #12).
2. Enter a valid number (0-2) on the dial pad.
[0] = Normal mode
[1] = Near end mode
[2] = Far end mode
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... Loopback setting is normal.
STARPLUS STSe - Programming & Operations Manual
C A LL I NG NUM BE R
E N AB LE D
LO OPBAC K
N O R MA L
Features and Operation
0-1
0-2
2-201
August 2005