Centrex/Pbx Flash Timer; Centrex/Pbx Transfer - Vodavi STARPLUS STSe Operation Manual

Centrex/PBX

Centrex/PBX Flash Timer

Description
Flash is a programmable opening on a line for signaling. When using an outside line, flash lets
a user obtain a new dial tone without losing the line. This is particularly useful behind a PBX
or Centrex. Each CO line can be programmed for a flash time.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press Button #21 to select Page C. The display updates. The following message displays to
indicate current programming of that line or group of lines:
4. Press the FLASH TIMER flexible button (Button #1).
5. Enter a valid number on the dial pad (01–20) which corresponds to 100 ms to 2 seconds.
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Flash Timer is set for 10 (1.0 seconds) and is variable from 01-20 (100 ms to
2 seconds).

Centrex/PBX Transfer

Description
When Centrex or PBX lines are connected to the STSe, users may, by using the Flash button,
transfer callers to other Centrex or PBX extensions. The Flash command may also be included
within a Speed Bin and programmed onto a flexible button for one button transfer. Consult
your Centrex user guide for further instructions after flashing the line. Refer to
Flash Timer" on page
STARPLUS STSe - Programming & Operations Manual
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
If HOLD is pressed without entering a CO line range, ALL CO lines are selected.
XXX - XXX PAGE C
E N T E R B U T TO N N U MBE R
XXX-XXX = CO Line Range
F L A S H T IM ER
1 0
2-59.
Features and Operation
01-20
2-59
"Centrex/PBX
August 2005