Co Line - Identification; Co Line Identification Display - Vodavi STARPLUS STSe Operation Manual

Starplus stse key systems
Hide thumbs Also See for STARPLUS STSe:
Table of Contents

Advertisement

2-76
Features and Operation
3. Dial a 0 or 1 to enable/disable this feature.
[0] = Disabled
[1] = Enabled
4. Press HOLD to save the entry. A confirmation tone sounds.

CO Line - Identification

Description
The CO Line Identification feature allows entering a name into the database for each
individual line (trunk) connected to the system. The name may be entered in any
combination up to 12-characters in length (this represents 24 digits entered). When the CO
line identification field is programmed, display telephones receive the identification field in
place of the default field (LINE XXX).
SMDR always prints the line number in place of the programmed name. A programmable
data field is available for each line in the system.

CO Line Identification Display

Description
The CO Line Identification Display feature allows the entry of a name for each line (trunk)
connected to the system. Once entered into the database, LCD phones, including the
Attendant stations, receive the programmed line name in place of the default LINE XXX
message. This applies to all line call processing conditions where the current LINE XXX
message displays. SMDR continues to print out the line number in place of the programmed
name. If the line name was not programmed, the current LINE XXX display is the default. A
programmable data field is available for each line in the system. Line names may be assigned
using the range programming.
A message similar to the following display is used for all CO Line displays when a name is
programmed for a CO Line.
Programming Steps
Each CO line can be programmed to have a name associated to it in database programming.
1. Press FLASH and dial [40]. The following message displays:
STARPLUS STSe - Programming & Operations Manual
L I N E RI N GI N G
n nnnnnnn nnnn
Entries can be made using a keyboard by following the same outlined
procedures using
Figure E-1: Data Terminal Program Codes Cross
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
CO Line - Identification
HH:MM a m
Reference.
August 2005

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents