Wink Timer - Vodavi STARPLUS STSe Operation Manual

Starplus stse key systems

Hide thumbs Also See for STARPLUS STSe:

Table of Contents

T-1 Trunking

Wink Timer

When Wink signaling is programmed, this timer determines how long the STSe system keeps

the T-1 TIE Line circuit reversed before any DTMF digits are sent from the Central Office. This

option allows the installer a method to adjust the Wink Signal on a per CO Line basis. The

Wink Signal can be used on DID and TIE-type trunks.

Programming Steps

1. Press FLASH and dial [40]. The following message displays:

2. Enter a valid number for the range of lines being programmed. If only one line is being

programmed, enter that number twice (001 001).

3. Press Button #21 to select Page C. The display updates. The following message displays to

indicate current programming of that line or group of lines:

4. Press the WINK TIMER Button (FLASH 40, Page C, Button #3) in the flexible button field.

The following message displays:

5. Enter a valid number which corresponds to 100-290 ms.

6. Press HOLD button to save entry. A confirmation tone sounds and the display updates.

DEFAULT ... Wink Timer is set for 140 ms.

STARPLUS STSe - Programming & Operations Manual

CO L I N E AT T R I B U T E S

S E L EC T A CO L I NE R A NG E

If HOLD is pressed without entering a CO line range, all CO lines are selected.

XXX - XXX PAGE C

E N T E R B U T TO N N U MBE R

XXX-XXX = CO Line Range

W I N K T IM E R

Features and Operation

Show Quick Links

Table of Contents