Incoming Intercom Ringing Flash Rate; Intercom Signaling Select - Vodavi STARPLUS STSe Operation Manual

2-188
Features and Operation
To answer an intercom call:
Lift the handset,
-or-
If your SLT is equipped with a speakerphone, press the Speaker button to converse in a
handsfree mode.

Incoming Intercom Ringing Flash Rate

Description
The Incoming Intercom Ringing flash rate is the rate an Incoming DSS button flashes if you
have a DSS appearance for the calling station. This flash rate can be programmed to
29 different options identified in the flash rate table. This enables the programmer to
customize the key system configuration to desired flash rates.
Programming Steps
1. Press the INC ICM RING flexible button (FLASH 07, Button #2). The following message
displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Incoming Intercom Ringing flash rate is set for Red 120 ipm Flutter (11).

Intercom Signaling Select

Description
Users can control the method by which they receive intercom calls and signals. A convenient
HPT button is located on each digital telephone for easy selection. The choices are:
Handsfree (H) -- The station user, upon hearing a tone burst and voice announcement over
the speaker, can reply handsfree.
Privacy (P) -- The station user receives a burst of tone and a voice announcement over their
speaker. The microphone is deactivated for privacy. The called party must lift the handset or
press the MUTE button to answer the call.
Tone Ringing (T) -- A standard tone ring notifies the party of an incoming intercom call. The
called party answers by lifting the handset or moving the switch to the handsfree (H) position
or pressing the ON/OFF button.
STARPLUS STSe - Programming & Operations Manual
I N C I CM RI N G
RED 120 IPM FLUT TER
Table 2-16 on page 2-163).
00-28
Intercom
August 2005