Toll Restriction Related Items - Vodavi STARPLUS STSe Operation Manual

2-328
Features and Operation
Programming Steps
1. Press the EXCEPT TABLES flexible button (FLASH 85, Button #5). The following message
displays:
2. To print the Except Tables, press the HOLD button. The following message displays:
When the system finishes sending the requested information to the printer, a
confirmation tone sounds.

Toll Restriction Related Items

CO/PBX Lines
When CO lines are marked as PBX lines the system first checks the PBX code table for a valid
match. If the first digits dialed do not match the entries in the PBX code table the call is
considered an attempt to call another PBX extension and no toll restriction is applied. If the
first digits dialed are found in the PBX code table (FLASH 12), toll restriction starts with the
next dialed digit.
Forced Account Codes
The system can be programmed to force the use of account codes on all restricted calls.
When forced account codes are enabled, an account code must be entered to place a call
that is otherwise restricted through toll restriction. By entering an account code, the station
class of service becomes unrestricted. When account codes are forced on a system-wide
basis, selected users may be instructed on how to enter account codes from any station and
be allowed to dial unrestricted from a station that may otherwise be restricted. Use of
account codes in this manner, as a traveling class of service, is however, not controlled by the
system. Any station user with knowledge of how to enter account codes to override a
station's toll restriction can do so.
SLT DTMF Receivers
When Single Line Telephones are connected to the STSe system and toll restriction is
enabled, the DTMF receivers located in the system monitors the call for a programmed time
period. While the DTMF receiver is monitoring the digits being dialed by a single line
telephone, it is considered busy and not available for monitoring another SLT attempting to
dial. When all DTMF receivers are busy, an SLT attempting to go off-hook does not receive
dial tone until a receiver is available.
The STSe system uses one DTMF receiver to monitor SLT dialing. If a system has heavy SLT
usage, then toll restriction may inhibit dialing by SLT stations.
STARPLUS STSe - Programming & Operations Manual
P R I NT E X TA B L ES
P R ES S HOL D
P R I NT IN G E X TA B L ES
Toll Restriction
August 2005