C-4
Flash-Based Voice Mail
Programming the Voice Mail System
The STSe must be programmed to recognize the slot location where the Voice Mail Interface
Board is installed. Also, the voice mail's system features must be programmed using a touch
tone telephone programming device and a personal computer. The following sections
describe these programming requirements.
Card Slot Programming
Description
The Card Slot Programming feature provides a means to assign the peripheral cards to
alternative peripheral card slots. The Voice Mail Interface Board can only be installed in slot 7
of the BKSU.
Related Information
Flash 80
Programming Steps
1. Press FLASH and dial [24]. The following message displays:
2. Press flexible Button # 8 to designate slot 7.
3. Enter a valid number [17] = VM1B (represents Flash-based VMIB) for the type of card
plugged into slot 7.
4. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
5. Press the reset button on the Main Board Unit (MBU).
Conditions
»
After programming card slots, a system reset must be performed.
STARPLUS STSe - Programming & Operations Manual
Quick Reference
Button #20 System Reset (refer to
C A BI NE T 0
E N TE R B UT TON NUMB ER
C A B 0
SLOT XX
D T IB
Programming the Voice Mail System
"System Reset" on page
2-298).
00-18
August 2005