Dial Pulse Sending; Dial Pulse Parameters; Pulse Dial Inter-Digit Timer - Vodavi STARPLUS STSe Operation Manual

Starplus stse key systems

Hide thumbs Also See for STARPLUS STSe:

Table of Contents

Dial Pulse Sending

Each CO interface circuit for outside lines can be programmed to send dial pulse or DTMF

By default, all lines are DTMF (tone) signaling. If pulse dialing is required, the individual

outside line must be programmed for Dial Pulse (DP). The dial pulse break/make ratio is fixed

at 60/40 and the dial speed of the dial pulse signal is fixed at 10 pps.

Programming Steps

Press the DIAL PULSE flexible button (FLASH 41, Button #1). The following informational

message displays:

This governs the inter-digit time of the Pulse Dial Digits, rotary dial mode. The Pulse Dial Ring

Timer setting is variable from 300-600 ms.

Programming Steps

1. Press the PULSE DIAL I/D TIMER flexible button (FLASH 02, Button #5). The following

message displays:

2. Enter a valid number on the dial pad that corresponds to 300-600 ms.

3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.

DEFAULT ... Pulse Dial Ring Timer is set for 300 ms.

STARPLUS STSe - Programming & Operations Manual

This program code is only used when an outside (CO) line is programmed for Dial

D I A L P UL S E

6 0 / 4 0 1 0 P P S

I N T D I GI T P UL S E

Features and Operation

Show Quick Links

Table of Contents