Call Forward
»
The calling station must have an appearance (Direct, Loop) for the outgoing (Off-Net)
line. The call is not forwarded if a Direct Appearance or LOOP key is unavailable.
»
SMDR printout reflects transferred and outgoing calls like a DISA call record.
»
Station users may use a Station or System Speed Dial Bin for Station Off-Net Forward.
»
Call must be an intercom or transferred CO call.
»
The Attendant station must have access to the CO Line group used in the speed bin for
the off-net forward to work.
Call Forward Button Flash Rate
Description
The Call Forward Button flash rate is the rate at which the Call Forward button flashes when
any type of forward mode is used. This flash rate can be programmed to 29 different options
identified in the flash rate table. This enables the programmer to customize the key system
configuration to desired flash rates.
Programming Steps
1. Press the CALL FORWARD BTN flexible button (FLASH 07, Button #3). The following
message displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Call Forward Button flash rate is set for a Red Steady On (01).
Conditions
»
This feature only changes the flash rate for the fixed feature button of STSe telephones.
STARPLUS STSe - Programming & Operations Manual
C A LL FOR WA RD BT N
R E D S T E A DY O N
Table 2-16 on page
2-163).
Features and Operation
00-28
2-33
August 2005