Incoming Ring Assignments - Vodavi STARPLUS STSe Operation Manual

Tenant Groups
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
4. Press the TENANT GROUP flexible button (Button #17).
5. Enter a valid number 0-9 to associate the CO lines to a Tenant Group 0-9 respectively.
6. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... All lines are set for Tenant Group 0.

Incoming Ring Assignments

Description
Incoming DID or DNIS call routing for Tenent Groups is programmed in this feature.
Programming Steps
1. Press FLASH and dial [43]. The Button #1 LED is illuminated and the following message
displays:
2. Either press Button #20 and enter a valid number for the route to be programmed or use
Buttons #18/#19 to scroll up or down to select the desired route, then press HOLD.
3. Press the TENENT GROUP flexible button (Button #10). The following message displays:
4. Enter valid number on dial pad (0-9) to specify the desired group.
5. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Tenent Group 0.
STARPLUS STSe - Programming & Operations Manual
XXX - XXX PAGE A
E N T E R B U T TO N N U MBE R
XXX-XXX = CO Line Range
T E NA NT GR O UP
0 0
R O U T E 00 0 D DD D RR
000 = Route Number (000-251)
DDDD = 3- or 4-Digit Ringing Destination Number
R = Ringing Type
T E NE NT GR O UP
0
Features and Operation
0-9
0-9
2-315
August 2005